It's that simple
80 cm from Felt ribbon cut off, wrap the rest around the willow wreath unevenly, secure the ends with hot glue. Cut the rest of Felt ribbon into four pieces of 40 x 7.5 cm each, also cut off about 90 cm of felt cord per rose. Lay the felt cord twice and place it on the narrow side of the felt ribbon. Important: For right-handed people the Cord-ends should point to the right, for left-handed people to the left
Twist the Felt ribbon around the Cord , fix it with Perlon thread and a few stitches. Turn the roll further while folding the Felt ribbon outwards to the triangle. With the bevel upwards, guide it around the roll and fix it at the bottom with a few stitches after each operation. Repeat the procedure until Felt ribbon is used up
Cut the enamelled copper wire slightly longer than the two cords and fix it at the base of the felt rose. Thread on glass wax beads and twist the finished bead wire with the felt cord
Tip: Thread twice through the beads to fix them on the wire. Attach a suspension made of felt cord to the wreath, then fix the roses and the maple leaves with hot glue. Wind single bead cords around the wreath or stick them in loops around the roses. Finally, glue a large glass wax bead into each felt rose. 
