Preparing the mixture
Start by mixing the VBS Kerahobby powder with water. Make sure to achieve a creamy consistency. Important note: Make sure that no powder settles to the bottom of the mixture and that all lumps are thoroughly dissolved.
Silicone casting mould "tin with lid": approx. 8 heaped tablespoons
Silicone casting mould "tin with lid", large: approx. 8 heaped tbsp.
Silicone casting mould "tin with lid", small: approx. 3 heaped tablespoons
Pouring into the mould
Pour the finished mixture evenly into your chosen silicone casting mould. To avoid air pockets and to ensure that the mixture is evenly distributed, gently tap or shake the mould on a flat surface.
Demoulding the castings
After waiting for about an hour, you can remove the castings from the mould. To ensure the best possible strength and durability, be sure to leave them to air dry afterwards.
Surface treatment
Go over any rough edges with sandpaper beforehand to smooth and perfect the surface of your castings.
Decorating the lids
Embellish the lids of the moulded tins by covering them with self-adhesive cork. Draw the outline of the lid on the back of the cork sheet, carefully cut out the shape and stick it to the lid.
Try it out and get creative!
Let your creativity run wild and create wonderful craft projects with our high-quality materials. Visit our online shop for a wide selection of Raysin powders and other craft supplies. Start your next artwork today and bring your creative ideas to life!
