It's as simple as that:
Protect your workplace first with a handicraft mat.
Silicone casting mold "coaster Oval":
Mix approx. 5 tablespoons of Raysin with water to form a creamy mixture. Then add the shell granules and stir vigorously. Pour the mixture into the silicone mould and tap it lightly on the surface so that the air bubbles rise. After approx. 30 minutes, you can remove the coaster from the mold. Tap it on the edge of the table to break it. Then put the individual parts back into the mold. Then mix some casting resin according to the instructions on the pack and pour it into the gaps in the mold so that the base is covered. Leave the casting resin to dry for 12 hours. Once dry, sprinkle some shell granules into the casting mold. Mix the casting resin again and fill the mold with it. After 24 hours Time to dry: you can remove the coaster from the mold. To seal the surface, mix some casting resin again and coat the surface with a brush. After another Time to dry: your coaster is ready.
Silicone mold "stick candle holder":
Mix a tablespoon of Raysin with a little water to make a creamy mixture and pour it halfway into the silicone mold so that only the future holder is filled with mixture. Tap the mold lightly on the surface so that the air bubbles rise. Leave the casting compound to dry for approx. 30 minutes. Then mix approx. 10 ml of casting resin in the measuring cup according to the instructions on the packet. Sprinkle some shell granules into the casting mold and pour the casting resin over them. Leave it to dry for 24 hours. Then mix approx. 1 tablespoon of Raysin with water again and fill the mold with it. After approx. 30 minutes, you can remove the casting from the mold. You can smooth the edge with sandpaper .
Silicone casting mold "kandelaar":
Mix approx. 4 tablespoons of Raysin with a little water to form a creamy mixture. Add some of the shell granules and stir again vigorously. Pour the mixture into the casting mold and leave it to dry for approx. 1 hour . Then carefully remove the casting from the mold. Moisten the sandpaper and sand the stick candle holder until the shell granules are clearly visible.
Tip: If your pillar candle is too large in diameter, you can sharpen it with the candle sharpener. To hold the candle firmly in place, place an adhesive wax plate in the base of the casting!
